How to Install a Sycamore Rod for a Pendant Light

Quick Answer

Installing a Sycamore Rod - RT adds 13 inches of drop to your Sycamore Chandelier. You'll attach it between the canopy and the existing rod using the included hardware.

Step-by-Step Installation of the Sycamore Rod

1. Turn Off Power: Switch off the circuit breaker controlling the pendant light. Use a voltage tester to confirm no power is reaching the wires. Never skip testing—even if the switch is off, the circuit may still be live.
2. Remove the Existing Fixture: Unscrew the canopy from the ceiling. Disconnect the wire nuts and separate the fixture wires from the house wires. Lower the chandelier carefully. Support the chandelier with one hand while disconnecting wires to prevent strain on the cord.
3. Attach the Sycamore Rod: Screw the Sycamore Rod - RT onto the threaded nipple at the top of the chandelier. Then attach the original rod to the other end of the Sycamore Rod. Hand-tighten only; overtightening can damage the threads.
4. Reconnect and Mount: Feed the wires through the rods and canopy. Reconnect the wire nuts (black to black, white to white, ground to ground). Push the canopy up to the ceiling and secure with screws. Double-check that no bare wire is exposed outside the wire nuts before tucking them into the canopy.
5. Test the Installation: Restore power at the breaker. Turn on the light switch to confirm the fixture works and hangs straight. If the light flickers, turn off power and recheck all wire connections.

Product Facts

• Sycamore Rod - RT: The Sycamore Rod - RT increases the drop length of your Sycamore Chandelier by 13 inches. This allows you to adjust the fixture height to suit your space, especially for higher ceilings or specific design preferences.